Open the fuel filler door. This allows residual fuel to drain back into the fuel tank and not spill onto the vehicle. Note: Always replace a fuse with one that has the specified amperage rating. Refer to the payload description and graphic in the Vehicle loading section. Failure to follow these instructions may increase the risk of injury in a collision. In case you require more chronological option, you can look at via the Glossary page.
When you open one of the front doors and you lock the vehicle with the power door lock control on the driver or passenger door trim panel , all the doors will lock, then all doors will automatically unlock reminding. These comments should be read and observed. Ford Motor Company recommends that all safety belt assemblies in use in vehicles involved in a collision be replaced. SeeEngine oilin the Maintenance and Specificationschapter for more information on oil usage. To avoid risk of injury, occupants should only use seating positions where they are able to be properly restrained.
This is particularly valid for halogen bulbs as the intensity of the light may be reduced if the hands touch the bulb. Driving the vehicle with less than the recommended fluid level may result in transmission failure. Press to return to the previous screen to advance to the next screen. Placing objects on or over the airbag cover may cause those objects to be thrown by the airbag into your face and torso or may result in a failure of the airbag to inflate properly, both of which could. Your primary responsibility is the safe operation of the vehicle. Hard objects can injure you in a collision. For routine cleaning, wipe the surface with a soft, damp cloth.
Ford strongly recommends that drivers use extreme caution when using any device or feature that may take their focus off the road. Oil levels above this mark may cause engine damage. Pull up the head restraint until it reaches the highest adjustment position. Contact your authorized dealer as soon as possible. Turn the key to 3 on without turning the key to 4 start.
The display will indicate the number of messages in your inbox. Erasing the Car2U Home Automation System buttons Note: The system allows for three devices to be programmed. After the objects are moved away from the seat, if the warning stays on or continues to come on, contact your authorized dealer as soon as possible. Make sure the headlamp switch is in the off position, then open the hood. Repairs will be made using Ford or Motorcraft parts, or remanufactured or other parts that are authorized by Ford.
If sprayed on the windshield, engine coolant could make it difficult to see through the windshield. Reverse the procedure to install the new bulb. Use of these systems may result in vehicle starting problems and a loss of security protection. The passenger cannot protect the child from injury in a collision. To adjust the head restraint, do the following: 1. Wipe the air filter housing and cover clean to remove any dirt or debris and to ensure good sealing.
If the glass has been handled, clean it with alcohol. Note: Turning Bluetooth Off will disconnect all Bluetooth devices and deactivate all Bluetooth features. Open the coolant bleed valve on the back of the engine water outlet for the 2. Install a new air filter element. This will restore full engine power and will enhance momentum through the obstacle. Protecting the environment We must all play our part in protecting the environment.
. To remove the floor mat, reverse the installation procedure. If you choose to install a remote start system please see your authorized dealer for a Ford approved remote start system. The more you know and understand about your vehicle, the greater the safety and pleasure you will derive from driving it. After you are done pumping fuel, slowly remove the fuel filler nozzle—allow about five seconds after pumping fuel before removing the fuel filler nozzle. With everything that we have to offer, it is our goal to become the most trusted and efficient platform to buy and sell cars online. Ford Motor Company and the vendors it uses to provide you with this information do not store your vehicle travel information.
Cleaning For dirt, use a vacuum cleaner then use a clean, damp cloth or soft brush. It is an integral part of the vehicle. Speed dependent wipers if equipped : When the wiper control is set to any of the interval settings except the longest pause setting, the pause time between wiping will automatically adjust with the vehicle speed. See Message center in the Instrument Cluster section for more information. Start the engine of the disabled vehicle.
Use 1 First gear and set the parking brake fully. In some Fiestas, you may need to re-enter a security code to get your radio to work again. Insert the dipstick fully, then remove it again. The headlamps will turn on. Copyright © 2010 Ford Motor Company.