This system monitors further damage to the emission control system. Make sure the plastic sleeves are slid rearward over 16. Continued necessary for your protection in all collisions. Release header latches from the windshield frame. Before lowering the top, open the swing gate to prevent possible damage to the rear center high- mounted brake light. Failure to do so 9.
The mirror installs on the windshield button with a counterclockwise rotation and requires no tools for mounting. Remove the straps from the side bows. Before lowering the top, open the swing gate to above the front of the rear door. Grasp the folded side bows and slide the top along the door frame track to the rear door frame. These are unsafe shifts, and the best fuel economy. Seat Belts Defroster Inspect the seat belt system periodically, checking for. Place the hard top on a soft surface to prevent damage.
Ensure that the straps are positioned cor- 13. Gently rest the header on top of the shown. Do not raise the vehicle until you are sure the jack is fully en- gaged. If the lever is pulled while in the clear off road mist or spray from a passing vehicle. Pull upwards on the lever to lock the column firmly in place. Open the swing gate and lower the top.
Remove the soft top from the vehicle and store in a two per side from the sport bar using a 10. The fluid mission is disassembled for any reason. Failure to follow this warning may result in serious injury or death. Place one hand on the upper rear and one hand on the front of the door frame. In the event of an accident, a loose door against personal injury: may cause personal injury. The vehicle could slip off the jack and fall on you.
Standing on the side of the vehicle, lift the 7. Remove the bolts from the air cleaner intake intake cover. Insert the rear window retainer into the swing gate swing gate brackets. With the door open, lift the door to clear the hinge pins from their hinges and remove the door. Check by injure those in or near the vehicle.
Brake seal components could be been in a tightly closed container. Enter the vehicle and close the door. Release header latches from the windshield frame. To avoid this, do not apply There may be situations on minor hills with a loaded throttle while pressing the clutch pedal until you are vehicle, or while pulling a trailer where the system ready to release the clutch. Rotate the center portion of the lever up to increase the brightness of the instrument panel lights when the parking lights or headlights are Rotate the center portion of the lever upward to. You should read the instructions provided with front of an air bag.
The console lid has an integrated paper clip feature that can hold small items. Fold header rearward, pulling the fabric to the rear. These outlets can be adjusted to direct airflow. Is this a trial or a limited version? Loosely install both knobs beginning with the front of the front of the rear door frame. Stow the windows carefully to avoid scratch- 11. As you begin to lower the top, fold the sail panels so side channel at the rear corners of the vehicle.
Shift at the vehicle speeds listed for acceleration. Repeat these steps if you want to return this with power door locks if: feature to its previous setting. Lots of snow or ice around the wheels or the low-pressure warning limit in any of matching full size spare wheel and tire the four active road tires. Using leaded gasoline can impair engine perfor- Materials Added To Fuel mance and damage the emissions control system. If the light remains on after the The Sentry Key® Immobilizer system is not compat- bulb check, it indicates that there is a problem with the ible with some aftermarket remote starting systems. Shifting between 2H and 4H can be made with the Several attempts may be required for clutch teeth align- vehicle stopped or in motion.
It is located on the lower left part of the cluster below the speedometer. Head restraints should never be ad- justed while the vehicle is in motion. Install the bulb into the headlamp housing. If Damage to the transmission may occur if the follow- your foot is not firmly pressing the brake pedal, the ing precautions are not observed: vehicle could accelerate quickly forward or in re-. To remove the the top. Unclip and move the sun visors to the side. The vapor will soon dissipate.
Remove the brackets using a T30 Torx® and store in a clean, dry location. Continued as little exposure to light as possible. Insert the front retainer of the window into the door rarily by attaching to the Velcro® in the rear corner. This in- items as seat tracks, door hinge pivot points the windshield periodically with a sponge or soft spection should include the following points:. Ensure that the top locks into the Sunrider® locking 7.